The MFM7-37ADSO-L5CD3 Hall Effect Gear Tooth Sensor is a large dynamic speed sensor. “DSO” type Hall Effect Sensors are digital single square wave output target trackers that detect 0-32 pitch gears and ferrous targets. Additional targets include ferrous bolt heads, holes in steel plates, and other magnetic targets.
The MFM7-37ADSO-L5CD3 Sensor uses load dump and EMI protected input and NPN output with a 5k pull up resistor. Furthermore, the sensor is potted in a plastic flange mount housing with wire leads and Deutsch DT 3 pin connector.
DSO Gear Tooth Sensors have a self-calibrating output that reacts to both the leading and falling edge of any ferrous metal target. No rotational orientation is required for the sensor to operate. Set the air gap relative to the sensing target face with the easy install flange mount design. The MFM7-37ADSO-L5CD3 sensor operates in the presence of a magnetic field, which causes the NPN output to go low.
Other features include:
- Greater air gap range
- Solid state (no wearing parts)
- Temperature stable
- Near 0 speed operation
- Dynamic, self-adjusting
|Actuator Material||Ferrous Metals, Gear Tooth|
|Supply Voltage, Vcc||4.5 ~ 28 V|
|Operating Temp.||-40 ~ 125 C|
|Termination Style||Wire Leads with Connector|
Aerospace, Agricultural, Automotive/Heavy Equipment, Consumer Electronics, Manufacturing, Marine, Medical, Military, Power Generation, TransportationSeries Data Sheet (PDF)